Selection of material from the LCD Panel

When you go to print from SD card through the LCD menu you can use both for the material that you want to go to print.

Clicking on the SD card menu you will see the choice between the following modes:

The printer will perform the print parameters defined during slicing.

Set the default parameter of ABS:
Nozzle temperature 230°;
Printing plate temperature 90°;
Fans speed 127 (for NG 0.1) off (for NG 0.2).

Set default parameters of PLA:
Nozzle temperature 220°;
Printing plate temperature 60°;
Fans speed 255.